Hi
I am trying to start the above engine

Any suggestions please

Thanks Basil
Moderators: Chantal, Tigger, KG Steve, peter
basil wrote:Allen Sythe Villiers 25 c four stroke.
Hi
I am trying to start the above enginebut it won't keep running. I think the compression is too low as there is hardly any resistance when you turn the engine over by hand. Can anyone tell me what the valve gaps should be, at the moment the inlet is 0.004" and the exhaust is 0.010".
Hi if you have a mk25c its 2 stroke?, 4 stroke is just mk25?, poor compression just as the chap says below if its 4 stroke, GL, George. at. www.villiersparts.co.uk
Any suggestions please![]()
Thanks Basil
pockets wrote:basil wrote:Allen Sythe Villiers 25 c four stroke.
Hi
I am trying to start the above enginebut it won't keep running. I think the compression is too low as there is hardly any resistance when you turn the engine over by hand. Can anyone tell me what the valve gaps should be, at the moment the inlet is 0.004" and the exhaust is 0.010".
Hi if you have a mk25c its 2 stroke?, 4 stroke is just mk25?, poor compression just as the chap says above if its 4 stroke, GL, George. at. www.villiersparts.co.uk
Any suggestions please![]()
Thanks Basil
Return to “Tools and Machinery”
Users browsing this forum: No registered users and 0 guests