FLYMO WITH TECUMSEH DELLORTO FHC 2013 CARB
Posted: Tue Sep 04, 2012 9:19 am
Hi
I have just acquired an old Flymo 2 stoke for the plot, It will run but only for a few seconds then it cuts out. I have striped the carb and given it a good clean and it runs better but still cuts. Looks like someone has tried to drill the centre spigot in the past. The engine is a Tecumseh with a Dellorto FHC 20 13 CARB. I have found a couple of similar carbs Dellorto FHC 20 13 A & E on ebay. 2 questions
• Will either of these fit ?
• Is there a new Tecumseh model on the market that will fit as I would rather buy a new carb that have to refurbish an old one.
Any advice would be appreciated
I have just acquired an old Flymo 2 stoke for the plot, It will run but only for a few seconds then it cuts out. I have striped the carb and given it a good clean and it runs better but still cuts. Looks like someone has tried to drill the centre spigot in the past. The engine is a Tecumseh with a Dellorto FHC 20 13 CARB. I have found a couple of similar carbs Dellorto FHC 20 13 A & E on ebay. 2 questions
• Will either of these fit ?
• Is there a new Tecumseh model on the market that will fit as I would rather buy a new carb that have to refurbish an old one.
Any advice would be appreciated