Page 2 of 2
Posted: Tue Apr 15, 2008 10:20 am
by richard p
i think the shape of the "teeth" on the metal disk is important, mine has four large teeth but the leading edges are at an angle so i think anything tough slides along the cutting edge rather than staying put to be cut, perhaps more of a saw tooth profile would be more efficient.
Posted: Thu Apr 17, 2008 11:04 pm
by Compo
I only want to cut grass and soft weeds but don't want the hassle of relacing and feeding line etc
Compo
Posted: Fri Apr 18, 2008 9:49 am
by richard p
size is the vthing.....a bump feed that takes a thick (2.4 or 3mm) line isnt a lot of hassle on soft grass and weeds,