Page 2 of 2

Posted: Wed May 03, 2006 6:44 am
by Clive.
Hello Tel,

Good to read that the job is being beaten into submission... :D

I summise then that the damage was not too deep into the seat after all.??

All the best,
Clive.

Valve Seat Cutting.

Posted: Sun May 07, 2006 10:37 pm
by Tel
Hi Clive,
The seats looked quite good after cutting.
After lapping however, some pitting showed itself.
I'll re-assemble & fire it up, B&S engines as you know take some hammering.
I reckon it'll run O.K.